4 Wire Stepper Motor

From Visuino
Revision as of 08:00, 10 June 2022 by Visuino (talk | contribs) (Created page with "Image:TArduinoStepperMotor4Wire.png == Summary == {{:Summaries:Summary 4 Wire Stepper Motor}} == Description == Use this component to control a 4 wire stepper motor. Please note that you should never connect a motor physically directly to an Arduino board, unless the board has built in motor drivers. You will need a hardware driver connected between Arduino and the motor. <b>Resources:</b> [http://www.instructables.com/id/Arduino-Nano-and-Visuino-Control-Ste...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Summary

Controls a 4 wire stepper motor

Description

Use this component to control a 4 wire stepper motor.

Please note that you should never connect a motor physically directly to an Arduino board, unless the board has built in motor drivers. You will need a hardware driver connected between Arduino and the motor.



Resources:

Instructable: Arduino Nano and Visuino: Control Stepper Motor with Buttons

Instructable: Arduino Nano and Visuino: Control Stepper Motor with Rotary Encoder

Diagram:

Categories

Properties

  • HalfStep - Specifies if the stepper motor will be controlled with half or full step
  • Enabled - Enables or disable the component.
  • Reversed - Specifies the direction of the stepper
  • StepsPerSecond - Specifies how many steps the motor should move per second

Pins

  • Out - The Digital Output pins of the component
  • Step - The Step Clock Input pin of the component