WiFi Shield: Difference between revisions
Jump to navigation
Jump to search
(Created page with "Image:TArduinoRemoteWiFiAccessPoint.png == Summary == {{:Summaries:Summary WiFi Shield}} == Description == Add this element to the Arduino Shields to control an WiFi Shield. == Used By == *Arduino Board.Shields - {{:Summaries:Summary Arduino Board.Shields}} == Properties == *AccessPoints - {{:Summaries:Summary WiFi Shield.AccessPoints}} *Sockets - {{:Summaries:Summary WiFi Shield.Sockets}} *TArduinoBasicN...") |
(No difference)
|
Latest revision as of 10:41, 9 June 2022
Summary
WiFi Shield element
Description
Add this element to the Arduino Shields to control an WiFi Shield.
Used By
- Arduino Board.Shields - Specifies the Shields attached to the Arduino
Properties
- AccessPoints - Specifies the Remote WiFi Access Points to connect to
- Sockets - Specifies the sockets of the WiFi Shield
- IPAddress - Specifies the IPV4 IP Address of the Shield
- Enabled - Enables or Disables the shield
Pins
- ScanNetworks - The Scan Network clock input pin of the WiFi Shield
- FoundSignalStrength - Return the RSSI /Received Signal Strength in dBm) of the the network discovered during the scan.
- FoundSSID - Return the SSID of the the network discovered during the scan.
- Address - Returns the Local IP Address
- MAC - Returns the Local MAC Address
- SignalStrength - Return the current RSSI /Received Signal Strength in dBm) associated with the network
- BSSID - Returns the BSSID - MAC address of the Access Point
- GatewayIP - Returns the Gateway IP Address
- SubnetMaskIP - Returns the IP Address Mask
- CheckSignalStrength - The Check Signal Strength Clock Event Input pin of the component