Stepper Ramp EDP: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
Line 20: | Line 20: | ||
DIR= Set the direction of travel for the stepper. | DIR= Set the direction of travel for the stepper. | ||
PUL = Send the step pulse to the stepper driver. | PUL = Send the step pulse to the stepper driver. | ||
== PROPERTIES == | |||
[[File:EDP_Stepper_Ramp2.png|200px]] | |||
Ramp Up/Down, High/Low timing delays, and Direction reversable. |
Revision as of 06:59, 14 June 2022
COMPONENT SUMMARY
EDP = (E)nable (D)irection (P)ulse controller setup commonly uses Pull Down settings.
Component Items
Fully customizable for use on automation projects.
INPUTS
STEPS = The total number of steps to be taken.
START = Reset to zero count and begin sequence.
STOP = Reset to zero count and stop all movement.
OUTPUTS
STEP COUNT = The current step in the sequence.
ENA = Enable the stepper driver.
DIR= Set the direction of travel for the stepper.
PUL = Send the step pulse to the stepper driver.
PROPERTIES
Ramp Up/Down, High/Low timing delays, and Direction reversable.