Stepper Ramp EDP: Difference between revisions

Revision as of 06:58, 14 June 2022

EDP = (E)nable (D)irection (P)ulse controller setup commonly uses Pull Down settings.

Fully customizable for use on automation projects.

STEPS = The total number of steps to be taken.

START = Reset to zero count and begin sequence.

STOP = Reset to zero count and stop all movement.

STEP COUNT = The current step in the sequence.

ENA = Enable the stepper driver.

DIR= Set the direction of travel for the stepper.

Revision as of 06:56, 14 June 2022 view source Visuino (talk \| contribs) Bureaucrats, Interface administrators, Administrators 5,337 edits No edit summary ← Older edit		Revision as of 06:58, 14 June 2022 view source Visuino (talk \| contribs) Bureaucrats, Interface administrators, Administrators 5,337 edits No edit summary Newer edit →
Line 18:		Line 18:

	ENA = Enable the stepper driver.		ENA = Enable the stepper driver.

			DIR= Set the direction of travel for the stepper.