Stepper Ramp EDP

COMPONENT SUMMARY

EDP = (E)nable (D)irection (P)ulse controller setup commonly uses Pull Down settings.

Fully customizable for use on automation projects.

STEPS = The total number of steps to be taken.

START = Reset to zero count and begin sequence.

STOP = Reset to zero count and stop all movement.

STEP COUNT = The current step in the sequence.

ENA = Enable the stepper driver.

DIR= Set the direction of travel for the stepper.

PUL = Send the step pulse to the stepper driver.

Ramp Up/Down, High/Low timing delays, and Direction reversable.