Weight Scale HX711
Summary
Reads data from HX711 Weight Scale
Description
Use this component to read data from HX711 Weight Scale.
Resources:
Instructable: Arduino Nano and Visuino: Measure Weight with HX711 Load Cell Amplifier and ADC
Diagram:
Categories
Category Measurement/Analog - Analog Measurement components category- Category Analog - Analog components category
Properties
- Powered - Specifies if the scale chip is powered
- ScaleDivider - Specifies the scale divide factor for the conversion into weight units
- Offset - Specifies the offset for the conversion into weight units
- UseChannelB - Specifies the HX711 channel to be used - A or B
- Gain128 - Specifies the gain for the programmable gain amplifier - 64 or 128
- Average - Specifies the number of measurement to be averaged to reduce noise
- Enabled - Enables or disable the component.
Pins
- SensorClock - The The Sensor's Clock Arduino Board pin
- SensorData - The The Sensor's Data Arduino Board pin
- Zero - The Zero scale Clock Input pin of the component
- Calibrate - The Calibrate scale Clock Input pin of the component
- Clock - The clock input pin of the component or element
- Out - The Analog Output pin of the component or element